Category Archives: rocket

Hotchkiss 39(H) with Wurfrahmen (Trumpeter 1/35)

 

Again: time to revisit an old build, since the previous posts covered a new Trumpeter kit.

I’ve already mentioned the tendency of the Germans to stick an 88 on anything that could carry it; they had a similar affectation towards Wurfrahmen rockets as well -they went on anything that moved: captured tanks, personnel carriers, half-tracks, anything. (I think the only combination they have not considered was sticking the Wurfrahmen rockets onto an 88…)

The H39 was an excellent platform for modifications, since they captured a lot in France. They were small, and quite inadequate in both armament and armor for the modern (a.k.a 1940) battlefield, however, they could be modified to no end, as they were well-made, and easy to maintain. I’m not aware of any report on the effectiveness of this weapon platform; in theory, it should have worked relatively well. After all, the tank is fast, well armored to be protected against small-arms fire and shrapnel, and had a small caliber tank gun, which could be used to defend itself if need came be. These tanks could -in theory- get close to the enemy, let loose a volley or rockets, and hastily depart with relative impunity. Then again; I might be wrong.

Well, this kit brings up some memories… An old-school Trumpeter model, when they were still kind of mediocre, but very cheap, but after their “not-so-good” (Type 59, anyone?) phase. Since then a lot of water has passed under the bridge, and Trumpeter became a serious competitor to Tamiya, Dragon and all the other “big ones”… (This can also be seen in the price of their kits.)

103554-b

The model had no real issues, and went together like a charm. After assembly I used Surfacer 500 to roughen up the hull; this gave an impression of the cast metal surface of the armor.

ql8ll1mwvujhb7

 

After the usual primer coat, the tank was painted with Tamiya Panzer Grey, the seams and some casting imperfections filled, and painted again.

mifq2za

 

I think the track is slack a bit… we get enough vinyl tracks for two tanks.

 

yppggbr

This is where I wanted to experiment a bit. I just got my airbrush recently back then (well, the compressor, to be honest; I’ve had an airbrush since I was 14, but I never had any means to use it). Ten years later, I got the chance, when some old lady in Boca Raton sold her unused compressor for peanuts. What I did was to dabble on different colors, which -I hoped- would show slightly through the next layer of panzer grey -kind of like a proto-pre-modulation technique. Had it worked, it would have looked awesome. As it was I went in with way too much paint for the next session, so everything got (almost) covered up. When you look at the tank in a good light, you kinda see the differently modulated grey. One thing is for sure: I’ll have to do some more experiments with this.

6drbbwt

It does look impressive, though.

 

The final coat and subsequent filters prepared from oil paints, made the model look very dark; back then I was not aware how much filters and washes darken the model…

0p4zsovujkqscoqbuqm5lphqsbib

 

The rockets are held in disposable wooden frames, which are held in place by a light metallic frame. Again: there were no issues with construction; the results are actually quite good.

myvjmt0gr0pgb7tyviwpu

Advertisements

Sturmtiger (Tamiya 1/35, Eduard PE+ resin)

rfzjlz6

 

The Sturmtiger always fascinated me; an over-the-top tank equipped with an even more over-the-top artillery piece that shoots over-the-top rockets. (A full grown man can fit into the stubby gun tube.)

stumrpanzeriv

What else can you ask for? Since the boxy superstructure has hidden the whole intriguing interior, I wanted to build my model with the interior somehow exposed. The best I could come up with was to simply cut the side open, as you can see it in the Imperial War Museum with their JagdPanther. The Tamiya kit only comes with a rudimentary interior; it’s sufficient if you only leave the hatches open, but it will be very poorly looking indeed if you open up the side as well. Solution: an aftermarket transmission (the very first resin AM part I’ve used, I think), and an Eduart PE set, aftermarket, turned metal rockets, and some resin Zimmerit. (I honestly cannot say where everything came from; I got them from Ebay a long, long time ago… this tank was built when I was still in Boca Raton, about 8 years ago.)

It took quite a lot of time to collect enough reference photos on the interior; and I’ve found out some interesting things about this monster. For example the whole superstructure is fixed to the hull only with those gigantic rivets on the side of the vehicle. If you ondo them, you can just lift the top off.

First I glued the resin Zimmerit to the hull; it went on much easier than expected. I only had to cut out the appropriate shapes, and use two-part epoxy to affix them to the model. It was simple as that; just make sure you don’t leave any bubbles when you place them onto the plastic surface. Any mistakes can be corrected using putty.

Anyhow; the interior was quite a big challenge for me at that stage of my model building life, but it started me down on a ruinous path: tanks with full interiors.

The transmission was a resin aftermarket item; since the Eudard PE set offered a really nice, PE replacement for it, the end part had to be removed.
hvxzprn

2kkg64a

 

The interior was dressed up using the Eudard set: the floor was improved considerably using the no-slip surfaces, the railings on the superstructure were added (as they were completely missing from the Tamiya kit), straps, radios, etc were added. All in all, they really improve the look of the interior.

myrdqqt

 

wwt6v4orm3obup

 

The painting was done using airbrush: the lower hull was given a primer red color, while the rest of the interior the typical German cream interior color.

hx0voj3fdbscy3natk2gv

Once everything was finished, I’ve added the rockets. I am not certain about it, but I think Tamiya has not provided a complete set of plastic rockets; I’ve bought some aftermarket ones made of turned aluminium, with PE rings on the bottom. (I think they were Tamiya made, by the way… the details are quite hazy after so many years.)
I’ve put the plastic ones where they were least visible, and the metal ones into the foreground.
I made sure that the rocket placed onto the loading rack has the fuse fitted.

6rjumj3p0oi8hmybxdo2tj1yvbj2l9wup2o

 

q8yc4ty

 

The superstructure was also a very interesting, very busy affair. There were a lot of extra parts added to make it look realistic.

 

ozflet8

(I still don’t know what those tubes are on the front wall…)

lcmlh2xygy4ln4lz7t7t3nm9wd1a

 

Once everything was finished (and very slightly weathered) I masked the openings with tape, and glued everything in place. I’ve decided on light weathering after looking at the photos taken by the US Army: the captured Sturmtigers were also spotlessly clean. They simply had no time to get worn down before being taken by the Americans.

 

66bzans

rngpgsg

clk1ltn

 

rymrco3izqqbnu

 

First paint layer7gxykvxmxohiji6uji5iuqb5lxwhktmoxe5

 

The roadwheels were steel rimmed; it was easier to paint them than the rubber rimmed varieties. Simply fix the wheels to a toothpick using blue tac, and touch them to a paintbrush loaded with metallic paint, roll, and you’re done.

dqodpyfkdmulkn

Masking was done with blue tac. I simply traced the outlines onto the hull using a pencil, and then filled them in with blue tac. It worked surprisingly well…

in4eyg9

l6chvos

 

The camo is almost finished. The mistakes were touched up using a paintbrush.

pzjmx3ox78eafho9klza5gryzu4tgryzu4t1

 

The last step was to add the dots onto the tank… not very entertaining, but it’s done pretty quick.

w2g8ou7lbhnpn7whizuvl

 

I sprayed a layer of Future Floorwax onto the model before applying any washes.

mrufdufnp2acca2mi5gkniahg9ql

 

The tank in it’s full glory after weathering… some washes, some drybrushing, and some pastel powder.

rfzjlz6dropy9vgv8u4j4hkp3ml9sfdkbzsavbptv5

Since back then (~2005…) not many people (meaning: myself) heard of filters yet, the weathering feels a bit incomplete: as I wrote washes, drybrushing and pigments (chalk dust) were used primarily. As soon as the SturmTiger comes out of storage, I intend to remedy this issue. (And probably take another couple of shots, as the crane for the rockets is not finished yet on these photos… this is what you get when you use archive material.)

 

qutzgz0
I have no idea what that small thing next to the tank is